Editing and Customization > Community Content
Community Map Pack
Graslu:
I think you should change the position of the PPK on each loading screen (like in the default ones), looks repetitive.
Also, in my opinion, it looks like plastic lol (the gun), so I would use GE:S one or find another. Would be good if you could use GE:S' font, too, it'll look really different when you read hints or just by comparing it to official ones.
markpeterjameslegg:
--- Quote from: Graslu on October 22, 2014, 08:11:44 pm ---I think you should change the position of the PPK on each loading screen (like in the default ones), looks repetitive.
Also, in my opinion, it looks like plastic lol (the gun), so I would use GE:S one or find another. Would be good if you could use GE:S' font, too, it'll look really different when you read hints or just by comparing it to official ones.
--- End quote ---
The GE:S guns are too low resolution, these screens are high resolution, therefore they wouldn't look right... I can work on the current weapon however, see if I can make it look less plastic, I do see what you mean on that point.
markpeterjameslegg:
I given the weapon a bit of a going over, looks better for sure, there was too much gamma before and I didn't notice until you mentioned it looked plastic...
markpeterjameslegg:
OK... I have taken on board the feedback of Jonathan [SSL] and Graslu and given the shadows more blur (I think that's what Jonathan meant?), also adjusted the lighting, contrast and gamma on the PPK, thanks to you both. Don't forget to zoom in and take a closer look, especially at the gun...
So what do you think? Should I carry on making the rest?
markpeterjameslegg:
With a silver PPK...
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version